CAME ZLX24SA Mode D'emploi page 95

Safety devices test
Check that the photocells connected to the selected inputs are operating correctly, after each opening and closing command.
Run the test by connecting the photocells to the TS terminal [see paragraph on Safety devices].
Confi guration>
Wired safety devices
RIO ED T1 and RIO ED T2
Associate one of the available functions with a wireless safety device.
The function only appears if the RIO CONN interface board is present.
Confi guration>
RIO safety devices
RIO PH T1 and RIO PH T2
Associate one of the available functions with a wireless safety device.
The function only appears if the RIO CONN interface board is present.
Confi guration>
RIO safety devices
Safety devices test
RIO ED T1
RIO ED T2
RIO PH T1
RIO PH T2
Deactivated (Default)
CX _ _ _
_ CY _ _
CX CY _ _
_ _ CZ _
CX _ CZ _
_ CY _CZ _
CX CY CZ _
_ _ _ CK
CX _ _ CK
_ CY _ CK
CX CY _ CK
_ _ CZ CK
CX _ CZ CK
_ CY CZ CK
CX CY CZ CK
Deactivated (Default)
P0 = It stops the gate and excludes automatic closing. Use
a control device to resume movement.
P7 = Reopen while closing.
P8 = Reclose while opening.
Deactivated (Default)
P1 = Reopen while closing.
P2 = Reclose while opening.
P3 = Partial stop. Only with [Automatic close] activated.
P4 = Obstacle standby.
P13 = Reopening during closure with immediate stop once
the obstacle has been removed, even with the gate not in
motion.