Getting Started - CAME ZLX24SA Mode D'emploi

Display symbols key
The encoder is deactivated.
The [Impact test] function is on.
The operator detected an obstruction when the gate was closing.
The operator detected an obstruction when the gate was opening.
The operator detected two obstructions when the gate was closing.
The number on the display varies according to the number of obstructions detected.
2
When the maximum number of detected obstructions has been reached, the operator stops and
an error message shows on the display.
The operator detected two obstructions when the gate was opening
The number on the display varies according to the number of obstructions detected.
2
When the maximum number of detected obstructions has been reached, the operator stops and
an error message shows on the display.
There is at least one programmed timer.
A programmed timer is running.
With the timer programmed for opening or partial opening, any given radio command will always
allow opening. The wired commands continue to operate normally.

Getting started

Once the electrical connections have been made, proceed with commissioning. Only skilled and qualifi ed staff
may perform this operation.
Make sure that there are no obstacles in the way.
Power up the device and follow the instructions on the display.
Start programming following the wizard.
If this is not the fi rst time the board is being switched on, go to the menu Confi guration > Wizard. Follow the
indications shown on the display.
Complete programming and check the warning and safety devices are working properly.
After powering up the system, the fi rst manoeuvre is always to open the gate Wait for the manoeuvre to be
completed.
Perform the fi rst manoeuvre where you can see the gate in motion and with the photocells active, including
where remotely controlled.
Press the ESC button or STOP button immediately in the event of any faults, malfunctions, strange noises or
vibrations, or unexpected behaviour in the system.
If CALIBRATION REQUIRED appears on the display, you must calibrate the travel. The panel will not accept
motion commands, except for the motor test.