Publicité
Les langues disponibles
Les langues disponibles
Picture 13
Picture 15
If fitting to the 959 '16-
•
Please make sure the engine is cold before proceeding with the fitting of the R&G cover.
•
Remove the side fairings from the right side of the bike. To do this, remove the row of fairing bolts
on either side which attach the lower to the upper fairing, along with the fairing bolts at the rear by
the swingarm pivot, the two bolts underneath the bike and the two bolts which are accessible on the
inside cowling surrounding the lower radiator.
•
To remove the upper fairing, remove the five fairing bolts along with the 2.5mm button head bolt on
the inside of the fairing at the front, before gently pulling the fairing out of its locating tabs.
•
To fit the engine case cover, the plastic cover that is arrowed in picture 1 needs to be permanently
removed from the bike.
•
Remove the two bolts that secure the cover to the engine case, as arrowed in picture 2.
•
Remove the two bolts that secure the front and rear of the cover for the ABS control unit, as arrowed
in picture 3 and as shown being accessed with a long Allen key or T-bar in picture 4.
•
Remove the plastic cover from the bike, as shown in picture 5.
Unit 1 Shelleys Lane, East Worldham, Alton, Hants GU34 3AQ
Tel: +44 (0)1420 89007 Fax: +44 (0)1420 87301
R&G R
ACING
www.rg-racing.com
Picture 14
Picture 16
Email:
info@rg-racing.com
Publicité
