Publicité
Les langues disponibles
Les langues disponibles
PLEASE READ THESE INSTRUCTIONS FULLY BEFORE STARTING
If fitting to the 1199 '12- & 1299 '15-
•
Please make sure the engine is cold before proceeding with the fitting of the R&G cover.
•
Remove the lower side fairing to allow access to the required bolts.
•
Remove the three engine case bolts in positions arrowed above. Hold the cover loosely over the case
to help identify the correct ones. DO NOT REMOVE ALL OF THE CASE BOLTS.
•
Offer up the R&G cover to the engine and carefully fit it over the engine casing. Ensure that the
R&G bolt holes are lined up with the holes in the engine casing, and then push on as far as it will go.
•
With a 5mm Allen key tighten the bolts equally so that they pull the cover into place. DO NOT
FULLY TIGHTEN.
•
Finally use a torque wrench set at 10 nm (7 Lb ft) to fully tighten.
•
Refit the lower side fairing.
•
It is suggested that you check the tightness of the mounting bolts on a regular basis i.e. when
cleaning or once a month.
•
NOTE for the cleaning of this product you should only use a soft polishing cloth and a mild general
cleaning agent
•
AVOID HARMFUL CHEMICALS IF IN DOUBT DO NOT USE AS THEY COULD ALTER THE
STRENGTH OF THE COVER.
•
R&G will accept no liability if the above procedure and torque settings are not followed.
Unit 1 Shelleys Lane, East Worldham, Alton, Hants GU34 3AQ
Tel: +44 (0)1420 89007 Fax: +44 (0)1420 87301
In this kit there should be
1 x Engine Case Cover (ECC0126R)
3 x M6 x 35mm long Cap Head Bolts
1 x Racing Puck (SK0001SK (already fitted))
2 x PAL Nuts (already fitted)
R&G R
ACING
www.rg-racing.com
Email:
info@rg-racing.com
Publicité
