Before You Start; Loading The Batteries; Ventilation; Maintenance Of External Surfaces - Pioneer VSX-C302 Mode D'emploi

Before you start

Before you start
Checking the supplied accessories
Please check that you've received the following supplied
accessories:
• AM loop antenna
• FM wire antenna
• Power cable
• Coaxialcable
• Dry cell batteries (AA Size / IEC R6P) x2
• Remote control unit
• Operating instructions
• Speaker cable labels
• Warranty card

Loading the batteries

The remote control operates on two AA batteries
(supplied).
1
2
3
Caution
• Incorrect use of batteries may result in such hazards
as leakage and bursting. Observe the following
precautions:
• Never use new and old batteries together.
• Insert the plus and minus sides of the batteries
properly according to the marks in the battery case.
• Batteries of the same shape may have different
voltages. Do not use different batteries together.
• When disposing of used batteries, please comply
with governmental regulations or environmental
public institution's rules that apply in your country or
area.

Ventilation

• When installing this unit, make sure to leave space
around the unit for ventilation to improve heat
dispersal (at least 0.7 ft. at the top, 1.7 ft. at the rear,
and 0.4 ft. at each side). If not enough space is
provided between the unit and walls or other
equipment, heat will build up inside, interfering with
performance and/or causing malfunctions. See
below for exceptions to this.
• Don't place anything on top of the receiver except for
a Pioneer DV-463, 363, 263, 260, 353, 251, 250, 578A
DVD player. If you do place one of these pieces of
equipment on top of the receiver be sure to leave the
ventilation space over it as prescribed above.
• If using a rack to hold the receiver make sure the
back of the rack and the left side are open.
• Also, if you're using a case with doors, leave the
doors open when using the receiver.
• Do not place on a thick carpet, bed, sofa or fabric
having a thick pile. Do not cover the receiver with
fabric or other covering. Anything that blocks
ventilation will cause the internal temperature to rise,
which may lead to breakdown or fire hazard.
• The receiver may become hot while in use, please
take care around it.

Maintenance of external surfaces

• Use a polishing cloth or dry cloth to wipe off dust and
dirt.
• When the surfaces are dirty, wipe with a soft cloth
dipped in some neutral cleanser diluted five or six
times with water, and wrung out well, and then wipe
again with a dry cloth. Do not use furniture wax or
cleansers.
• Never use thinners, benzine, insecticide sprays or
other chemicals on or near this unit, since these will
corrode the surfaces.
5
En