Setting Individual Channel Levels - Pioneer VSX-C302 Mode D'emploi

The System Setup menu

Setting individual channel levels

Use to set the relative volume of each channel as you find
necessary for balanced surround sound.
RECEIVER
CH SELECT
1 Use MASTER VOLUME to adjust the volume to an
appropriate level.
2 Press TEST TONE to output the test tone.
The test tone is output in the following order (from
speakers that are switched on and are appropriate for the
current listening mode):
• L – Front left
• C – Center
• R – Front right
• RS – Right surround
• LS – Left surround
• SW – Subwoofer
3 Use the LEVEL +/– buttons to adjust speaker
levels so that you hear the test tone at the same
volume from each speaker when seated in your main
listening position.
• The channel level range is ± 10 dB.
4 Press TEST TONE to turn off the test tone.
Note
• Since the subwoofer transmits an ultra-low
frequency its sound may seem quieter than it actually
is. Be careful not to turn up your subwoofer too much
and check the volume with an actual source.
• The subwoofer volume is best controlled with the
volume control on the subwoofer unit itself.
• The speaker volume can be adjusted without
outputting the test tone by pressing CH SELECT then
using the LEVEL +/– buttons. This level setting mode
is automatically exited after 5 seconds of inactivity.
• The default setting is 0 dB for all channels.
MASTER
VOLUME
TUNE
TUNE
TEST TONE
09
35
En