Before You Start; Basic Playback - Pioneer VSX-430-K Guide Rapide

Before you start

1
Put the batteries in the remote control.
2
Switch on the receiver and your TV.
3
Switch the TV input so that it connects to the
receiver.
4
Turn the subwoofer on and turn up the
volume.
5
Perform manual speaker setup.
Refer to "Manual speaker setup" in the CD-ROM operating
instructions for details on how to perform the setup.
CAUTION
• Do not use or store batteries in direct sunlight or other
excessively hot place, such as inside a car or near a
heater. This can cause batteries to leak, overheat, explode
or catch fire. It can also reduce the life or performance of
batteries.
• When inserting the batteries, make sure not to damage
the springs on the battery's  terminals. This can cause
batteries to leak or overheat.
• When disposing of used batteries, please comply with
governmental regulations or environmental public
institution's rules that apply in your country/area.

Basic playback

Playing a source
INPUT SELECT
Note
• When a sound can not be heard from center and rear speakers, press ALC/STANDARD or ADV SURR to change listening
modes.
E.g.) Press the ADV SURR for several times to select EXT.STEREO.
• In order to listen to the audio from the source component that is connected to this receiver using a coaxial or an optical
cable, choose the C1 (coaxial) or O1 (optical) input. (Press SIG SEL.)
• If there's no sound from the subwoofer:
– When the front speaker is set to LARGE then, in some cases, no sound may come from the subwoofer. Change the front
speaker setting to SMALL or change the subwoofer to PLUS and the sound should be restored. If the front speaker has good
low range playback capabilities then it is recommended that you do not change the settings. (Refer to "Home Menu" 
"Manual speaker setup" in the CD-ROM operating instructions
• If the remote control isn't responding:
– In order to control the receiver using the remote control, first press
– In order to control TUNER or USB, first press TUNER or USB.
• If the power suddenly turns off:
– There is a possibly that the speaker cord's exposed wire is in contact with the rear panel or another exposed wire, triggering
the protection circuit. Firmly retwist the speaker's exposed wire and connect it ensuring that it isn't sticking out from the unit
or the speaker terminal on the speaker.
LISTENING
MODE
VOLUME
for details)
.
RECEIVER
© 2015 PIONEER HOME ELECTRONICS CORPORATION.
All rights reserved.
5