Safety Instructions - Aqua Medic BLENNY Mode D'emploi

4. Skimmer EVO 500
See attached manual.
The skimmer is hung on the middle separating wall of the filter chamber without holder. The pump
has to be inserted without basket.
Available spare parts: Please refer to www.aqua-medic.de.
5. Illumination
LED light incl. 3 x aquasunspot 3 x 3 W
5.1. Technical data, table 1:
Type
Voltage LED
Power uptake per spot
Line voltage transformer
Maximum power
Light: aquasunspot 3 x 3 watts (2 x 10,000 K + 1 x blue) with a 2 pin socket MR16.
5.2. Assembly
On unpacking, please check the lighting system immediately for any damages. In case of any
complaints, please contact your dealer directly.
The three holding units for the light have to be put on the back pane of the aquarium.
aquasunspots are put in the sockets by using a Philips screwdriver.
Afterwards, each light has to be put in the corresponding holding unit. The shorter light has to be
put into the middle. The light power lines have to be connected to the transformer.

5.3. Safety Instructions

The lights may become very hot during operation. Be careful when touching them!
•
In case of changing bulbs, disconnect the light from the mains and let it cool down.
•
When cleaning, take care that no humidity passes the ventilation and enters the interior of the
•
lighting system!
aquasunspot 3 x 3 W
12 V
9 W
100 – 240 V, 50 – 60 Hz
12 V / 3 A
7