Aqua Medic BLENNY Mode D'emploi page 6

1. Product description
Following parts are included:
- Aquarium 40 x 50 (incl. filter chamber) x 40 cm
- Skimmer EVO 500
- Current pump EcoDrift 4.1
- Illumination 3 x aquasunspot (9 W each)
- Filter separating wall
- Filter basket for taking up activated carbon or phosphate absorbers
A timer and a socket board are not included.
2. Set-Up of the aquarium
The aquarium can be placed directly on a sufficiently solid cabinet or desk. Beforehand, the cabinet
plate and the lower surface of the aquarium should be cleaned to prevent the bottom pane of glass
from bursting through grains of sand or any dust particles.
First of all, the aquarium has to be cleaned with clear water. Afterwards, the protective plastic film
has to be pulled off the black plastic rear wall (if applicable).
The lower edge of the rear wall has a lip made of self-adhesive foam rubber. Wipe any fingerprints
off the lower edge by using a dry cloth. Remove the protective plastic film from the self-adhesive
strip, apply and remove any excess rubber.
Now, push the rear wall into place.
3. Current pump EcoDrift 4.1
See attached manual.
The pump is open at the front. Therefore, it should never be started uncontrolled. Animals
could be found in the sucking in basket and they could be injured or killed by the starting propeller.
The pump has to be adjusted in such a way that the water level in the filter chamber is
not greatly reduced or fluctuates. Otherwise, the skimming process is not working.
The pump is attached to the filter separating wall by using the magnetic holder, so that the outflow
opening extends into the recess of the separating wall (see Fig. 1).
Fig. 1: Mounting the EcoDrift 4.1
6