Installation Procedure - Toto TLP01701U Manuel D'installation Et D'utilisation

NOTE:
Before installing the faucet, be sure to
thoroughly flush the supply pipes of
dirt and debris. Then, shut off the water
supply at the stop valves. See the rough-
in dimension page to determine the
correct location for the controller.
1. Mount the inlet brackets on the wall
(ill. 1). Use wall anchors if necessary
(not provided). Brackets MUST be
mounted 3-¾" (95mm) apart (center
to center) to connect correctly to the
controller. Make sure there are no
obstructions to the inlet brackets.
IMPORTANT!
Be sure to mount each water inlet
bracket in the correct upright direction
as shown (ill. 1). Otherwise, the strainer
on the water inlet bracket will be
inaccessible for cleaning.
2. Remove the controller cover (ill. 2).
3. Connect the controller to the water inlet brackets (ill. 3) Connect the
flexible hoses to the bracket inlets.
ill. 3
H

INSTALLATION PROCEDURE

ill. 1
I
J
95mm
ill. 2
H
I
I
5
I
J
F
G