Testing And Calibration; Temperature Adjustment - Toto TLP01701U Manuel D'installation Et D'utilisation

Masquer les pouces

Table des Matières

Les langues disponibles

„ Turn on the water supply

ƒ Turn on the water supply at the stop valves and inspect all the

connections for any leaks (Ill. 10).

„ Flow rate adjustment

ƒ If flowrate adjustment is necessary because the wash basin is too small or

the water pressure is too high, turn the stop valve(s) clockwise to limit the

flow. Confirmation of wash basin specifications is highly recommended

before installation of the Automatic Faucet.

„ Temperature adjustment

ƒ The water temperature has been factory set at 100°F (38°C, Max: 42°C ±

3°C). Depending on the supply water pressure and other local conditions,

the water temperature may not be kept as specified. In such a case,

adjust the temperature by turning the temperature control handle (Ill. 11).

ƒ NOTE: If turning the temperature control handle changes the

temperature opposite of the direction indicated, make sure the hot water

supply is connected to the left inlet bracket.

„ Adjusting maximum outlet temperature

1. Shut the water off at the stop valves.

2. To decrease temperature:

Remove screw and pull handle slowly to remove. turn handle counter-

clockwise one notch and reinstall onto cartridge.

To increase temperature:

Remove screw and pull handle slowly to remove. turn handle clockwise

one notch and reinstall onto cartridge.

3. Secure handle with screw.

4. Open shut off valve.

5. Check water temperature.

**Repeat steps 1-5 if necessary.

Ill. 10

Open