Submerging The Cleaner Into The Pool - Kokido DRAKBOT Manuel D'utilisation

- Do not restart the cleaner immediately after it stops. Wait for at least 30 seconds
before restart.
- Do not drive the cleaner out of water. Otherwise, it will damage the cleaner
- Must clean out the debris from the cleaner and mesh filter plate before each
operation. Refer to "CARE & MAINTENANCE" section for how to clean the debris.
Excessive debris inside the cleaner will change the cleaner's weight and speed; cause it
to deviate from the selected path.

Submerging the cleaner into the pool

- Use the cleaner handle to lift the device, hold the cable with your free hand, and
gently place the cleaner into the water. Make sure the front of the cleaner (other side
of the cable) is facing the water upon entry. Continue to hold the cable until the
cleaner is filled with water (no more bubbles escaping) and begins to sink to the pool
bottom. Release the rest of the cable. The cleaner is ready to operate.
For pools with a flat bottom, release the cleaner from the middle of the longer side of
the pool.
For sloped pools, release the cleaner from the flat bottom side of the pool and make
sure the cleaner is facing towards the slope
Note:
1. In order to avoid causing scratches / damage to the pool wall (particularly
vinyl and soft wall pools), be sure to prevent the cleaner from making any
form of contact with the pool wall during placing the cleaner to the pool.
2. Make sure the mesh filter plate is in place before placing the cleaner into the
water.
3. Make sure the fiter tray is secured by the side knobs. Side knobs should
completely clip into the cleaner, as shown below, by pressing the knob
inward.
13