Working Mode Selection; Control Panel; Power Connection - Kokido DRAKBOT Manuel D'utilisation

CAUTION:
- Ensure all the air inside has been evacuated completely (when you no longer see air
bubbles discharged from the cleaner) and the cleaner sinks to the bottom of the pool.
- Spread out the floating cable over the pool water surface as evenly as possible, and
make sure there are no kinks or coils in the cable.
- Do not place the cable plug in water.
- Do not move the floats along the cable

Working mode selection

Control Panel

CAUTION! Do not lift the protective film on the control panel.
*Tap (hold for 1 second) the button to trigger the feature.
Tap "ON/OFF" to power on; indicator light of mode used during last operation begins to
flash. Tap "CYCLE" button to select desired mode. Once the operation is finished, all 3
indicator lights will flash simultaneously.
Pool shape, water depth and its bottom flatness are potential factors affecting the
cleaner moving in the pool. If your pool size is already the maximum size that the
cleaner is recommended for, select "L" mode, otherwise, select "M'' as the initial start.
Observe the cleaner moving pattern and change to other selection if necessary. In
addition, make sure the nozzle setting is properly selected.
Note: It will restart the last operated mode over again every time you power on the
unit.
CAUTION: Do not restart the cleaner immediately after stopping. Wait for at least 30
seconds before restarting.

Power connection

WARNING!
- The power cord must be connected to a receptacle protected by a residential current
device (RCD)/ground fault circuit interrupter (GFCI). Do not use an extension cord to
connect the cleaner to electric supply; provide a properly-located electric outlet. The
Selection
Item Feature
mode
1 ON/OFF
2 CYCLE
Indicator
3
light bar
Function
Power On/Off
About 1 hour operation.
S
About 1.5 hours
M
operation.
L About 2 hours operation.
Corresponding light bar
begin to flash after the
mode is selected.
14