Storage Of The Cleaner - Kokido DRAKBOT Manuel D'utilisation

3. Lift and remove the filter tray (together with the mesh filter plate).
4. Remove the debris thoroughly from the inside of the cleaner.
5. Use water to clean the mesh filter plate. Note: If the mesh filter plate is damaged,
replace the unit before next operation.
To detach the mesh filter plate from the tray, push the hook to release its position on
the notch along the frame.
Replace the new mesh filter plate by pressing the small hooks to the notches.
6. Put the filter tray (installed with mesh filter plate) back to the cleaner.
7. Position the cover correctly by aligning and placing its bottom flange into the filter
tray. Push the side knobs outward to allow the cover go into the position.
CAUTION! Never push forcefully to attach the cover directly as it could damage the
unit and the side knobs.
Tips: If you encounter the symptoms listed below with your cleaner, then perhaps it is
time to clean the filter bags, as well as the interior of the cleaner:
- Cleaner slows down considerably
- Cleaner fails to remove debris
- Cleaner turns in different path constantly

Storage of the cleaner

- Reverse the steps of assembly to disassemble the cable from the Power Supply and
Control unit. Use a clean cloth to sweep the Power Supply and Control unit and cable.
The cable should be wound up for storage.
- Drain the water from the cleaner.
- Use clean water to flush 1) the interior and exterior of the cleaner 2) the filter tray ,
mesh filter plate and cover (interior and exterior).
- Place the cleaner on a clean and level surface free of any sharp object that could
16