Set Up; Placement Of Power Supply And Control Unit; Connecting The Cleaner Cable To The Power Supply And; Installing The Brush On The Cleaner - Kokido DRAKBOT Manuel D'utilisation

SET UP

Placement of power supply and control unit

Make sure the Power Supply & Control unit is placed at a spot where the length of the
cable allows the cleaner travels to reach every corner of the pool.
WARNING! The Power Supply & Control unit should be placed in a dry, sheltered area
at least 3.5 meters (11.5 feet) from the edge of the pool. The Power Supply & Control
unit should not be left exposed in the rain or placed in puddles of water. NEVER
submerge this unit in water.
In order to prevent the Power Supply & Control unit from being accidentally carried
into the pool during the operation, the user is strongly recommended to use a rope &
hook provided to secure the unit to a fixed location.
Connecting the cleaner cable to the Power Supply and Control
unit
WARNING!
- Do not connect Power Supply & Control unit to the power before connecting the
cable.
- Never touch the plug and socket with wet hand or body, or while standing in water.
Plug the cable into the socket of the Power Supply & Control unit by aligning the notch
on the plug to the rib on the top of socket inside. Push the plug into the socket and
turn the plug screw cap clockwise.

Installing the brush on the cleaner

-
Align the hooks on the bar with the holes on the cleaner's bottom as shown, and
press each hook into the holes until they are all secured.
9