Adjustment Of Trajectory; Locking Pin; Bumper; Pool Preparation - Kokido Mangar RC32 Manuel D'utilisation

Adjustment of Trajectory

Locking Pin

The trajectory of the robot is dependent on the position of the pin that fixes the axle to
a certain angel. There are rwo locking pins: the one on the right is fixed and should
remain untouched. Alter only the position of the pin on left.
Recommended settings:
For pools where the shortest length is 3
meters or below. (Factory setting)

Bumper

The bumper is optional and can be used in the following situation:
If the robot tends to follow the perimeter of
the round pool, clipping a bumper on each
side of the robot will eliminate this pattern.

Pool Preparation

- If there are stones, roots or metal corrosion in contact with the underside of the liner,
discard them prior to using the robot. If necessary, seek assistance from a qualified
professional.
- If the liner is brittle, damaged or wrinkled, contact a qualified professional to perform
the necessary repairs or perform a liner replacement prior to using the robot.
- It may be advisable to turn off the filtration system as water circulation in the pool
may affect the movement pattern of the robot.
- Remove any pool ladder, surface skimmer, and other floating objects from the pool
as they may obstruct the movement of the robot's float and, consequently, the
movement of the robot also.
For pools where the shortest length is 3
meters or above
13