Pool Preparation - Kokido Delta 200 Manuel D'utilisation

Pool Preparation

- If there are stones, roots or metal corrosion in contact with the underside of the liner, discard them prior to using the robot.
If necessary, seek assistance from a qualified professional.
- If the liner is brittle, damaged or wrinkled, contact a qualified professional to perform the necessary repairs or perform a liner
replacement prior to using the robot.
- Remove any pool ladder, surface skimmer, and other floating objects from the pool as they may obstruct the movement of
the robot's float and, consequently, the movement of the robot also.
- If you are using a saltwater pool, make sure all salt are dissolved before placing the robot into the water.
IMPORTANT NOTE: Turn off the filtration system (as instructed in your filtration manual) at least 15 minutes prior to
deploying the robot.
OPERATION
WARNING!
- Make sure the robot is off.
- Ensure the charging plug is detached and the charging port is plugged with the protective cap
before the robot is deployed.
1. Bring the robot to the side of your pool. NOTE: Only deploy the robot from the pool side (not the pool corner) and ensure it
is facing outwards as you do so. Unwrap the retrieval cord from the float (note: there are side notches at the top and bottom
of the stem, as well as a narrow slot at the bottom).
The correct length of the rope should be equivalent to the distance between the top of the robot and the water level.
NOTE: Excess length may kink the rope and affect performance as a result.
7