Troubleshooting - Kokido DRAKBOT Manuel D'utilisation

damage the cleaner.
- Store in a dry, sheltered area where the temperature is between 5°C – 35°C.
- Do not leave the cleaner and its components to dry in direct sunlight.
- The Power Supply & Control unit should not be left exposed in the rain or placed in
puddles of water.
Never store the cleaner and its components close to any pool chemicals as chemical
fumes and / or spills could cause severe corrosive attack to them.
WARNING! Cleaner and components must be kept away from being used as means of
access to the pool by children.
TROUBLE SHOOTING
Symptom Possible reason
Running time is too long
Nozzle was set on large degree
Cable twists
Cable was not fully released
or coils up
Obstruction in pool
Excess cable in the pool
Gets stuck on main drain cover
Nozzle was set in improper
degree
Customized pool shape
Cleaner
does not
Power Supply & Control unit was
reach all
not positioned properly
pool areas
Pool filtration system is on
Cable not long enough in pool
Power cord is not
well-connected
Cleaner
does not Damaged during transportation
work
Local rated voltage is not
suitable for cleaner
Cleaner
does not
Air trapped inside cleaner
sink to the
pool bottom
Cleaner inside or mesh filter
Cleaner plate is clogged with excessive
does not debris
catch the Rectangular suction nozzle at
debris
the bottom of the filter tray is
clogged.
Suction nozzle door is clogged
Debris
and opened
escapes
Suction nozzle door detached
from the
cleaner
Corrective actions
Stop the cleaner and uncoil the cable manually.
Adjust nozzle to the smaller degree. Refer to section
"How the cleaner works" & "Propelling nozzle
setting"
Unplug power line, release cable
Remove obstruction in pool
Remove excess cable from the pool and determine
the required length of cable.
Turn off pool filter system
Refer to section "How the cleaner works" &
"Propelling nozzle setting".
Adjust the nozzle to large degree for a larger moving
radian path. Refer to section "How the cleaner
works" & "Propelling nozzle setting"
Relocate the Power Supply & Control unit to a spot
where the cleaner can have enough cable length to
move in the entire pool.
Turn off pool filter system to stop the water
circulating as that might affect the cleaner's
coverage.
Release more cable into the pool.
Re-plug the power cord and cable line according to
the instructions provided.
Contact local dealer.
Contact local dealer
Turn off the power; submerge the cleaner in the
pool again according to the instructions listed in this
manual. Contact dealer if it is a frequent occurrence.
Clean the cleaner inside and the mesh filter plate .
Clean the suction nozzle.
Clean the suction nozzle
Follow below steps to attach the door to the
opening:
1) Place the spring onto the door side post as shown
17