Set-Up Before Use; Handle Assembly; Telescopic Pole Connector Assembly; Filter Base Unit Assembly - Kokido Telsa 80 Manuel D'emploi

time of the pool vacuum will gradually reduce through repeated charging and
discharging in operation.
NOTE: Let the pool vacuum rest for around 30 to 40 minutes before charging it again.

Set-Up Before Use

Handle assembly

Insert the handle into the pool vacuum as shown, until the side pin on the handle is
secured to the handle's locking hole on the rear body.
To release the handle, press down on the side pin and pull out the handle.

Telescopic pole connector assembly

Pull to detach the locking pin from the pole connector. Align the holes on the front
arms of the pole connector to the holes of the hinge on the transparent lid. Insert the
locking pin through all the holes in order to secure the pole connector on the lid.

Filter base unit assembly

First, place the dome filter screen onto the base. Then, place the transparent lid on
top and align both orange line markings. Make sure the flange of transparent lid is not
resting on any of the arches of the base.
Push on the tab to turn the transparent lid in the same direction as the red arrow
(anticlockwise) until all tabs reach the arches and lock the transparent cover in place.
9