Set-Up Before Use; Floor Squeegee Assembly; Adjustment Of Trajectory; Locking Pin - Kokido Vektro Auto RC30 Manuel D'utilisation

NOTE: Let the robot rest for around 30 to 40 minutes before charging it again.

Set-Up Before Use

Floor Squeegee Assembly

Align and insert all squeegees into the notches on the underside of the robot

Adjustment of Trajectory

Locking Pin

The position of the pin locking the axle will affect the trajectory. There are two locking
pins: locking pin on left is fixed and should remain untouched. Chang the right pin
location.
Factory setting of the pin
for all types of pool.
If the robot trajectory is too
curved, pull out the pin and
insert it in this hole. Make
sure the wheel axle is
positioned below the axle.
To increase the curve of
the trajectory, remove the
pin from the hole and insert
it in the hole which is
located above the pin hole
as shown
9