Set-Up Before Use; Adjustment Of Trajectory; Locking Pin Setting (Default Position); Swivel Fin Setting - Kokido Manga X Manuel D'utilisation

Note: Clean the debris compartment regularly. Excessive debris inside the debris
compartment increases the burden to the motor operation and shortens the operating
duration as a result.
NOTE: Rechargeable lithium-ion battery is classified as a consumable item. It has a
limited life and will gradually lose its capacity to hold a charge. Therefore, the running
time of the robot will gradually reduce after repeated charging and discharging
throughout its product life.
Replace the battery by swapping for a new swivel head. Follow step 1 in "How to
remove battery pack" section to detach the swivel head and reverse the steps to
install a new one.
NOTE: Let the robot rest for around 30 to 40 minutes before charging it again.

Set-Up Before Use

Adjustment of Trajectory

The trajectory of the robot is dependent on the default position of the locking pin and
turning angle of the swivel fin as instructed. Alter only the turning angle of swivel fin.

Locking Pin setting (Default position)

Swivel Fin setting

For pools where the shortest length
is 3 meters or below.
Default
angle
For pools where the shortest length
is 3 meters or above
12