Vehicle Preparation - Subaru H001SXC200 Manuel D'installation

4

VEHICLE PREPARATION

1. Using a 10mm socket/ratchet, disconnect the negative
battery cable. (FIGURE A)
NOTE: Do not disconnect the battery terminal from
the battery post.
2. Open the glove box and press inward on the sides of
the glove box to disengage the retaining tabs from the
glove box inner cover. Disconnect the strut from the
glove box. (FIGURE B)
3. Using a panel removal tool, carefully remove the right
side dashboard panel by starting at the top and working
downward to disengage six (6) pressure clips.
(FIGURE C)
4. Using a panel removal tool, carefully remove the
passenger’s side ornament panel by lifting upward to
disengage eight (8) pressure clips and then pulling
toward the rear of the vehicle. (FIGURE D)
5. Using a Phillips screwdriver, remove six (6) Phillips
screws securing the glove box inner cover. Disengage
the six (6) pressure clips and disconnect the glove box
lamp connector to remove the glove box inner cover.
(FIGURE E)
FIGURE D
ISSUE
PART NUMBER
H001SXC200
DATE
-
24 May 2022
FIGURE A
FIGURE B
FIGURE C
FIGURE E
SUBARU OF AMERICA
2 OF 9