Vehicle Preparation - Subaru H001SVC100 Instructions D'installation

4

VEHICLE PREPARATION

1. Using a 10mm socket/ratchet, disconnect the negative
battery cable. (FIGURE A)
NOTE: Do not disconnect the battery terminal from
the battery post.
2. Open the glove box and press inward on the sides of
the glove box to disengage the retaining tabs from the
glove box inner cover. Disconnect the strut from the
glove box. (FIGURE B)
3. Using a panel removal tool, carefully remove the right
side dashboard panel by starting at the bottom access
notch and working upward to disengage six (6) pressure
clips. (FIGURE C)
4. Using a panel removal tool, carefully remove the
ornament panel by starting at the back of the lower
right corner to disengage (4) pressure clips and one (1)
fi nger clip. Pull rearward to remove the passenger's side
ornament panel. (FIGURE D)
5. Using a Phillips screwdriver, remove seven (7) Phillips
screws securing the glove box inner cover. Disengage
the six (6) pressure clips and disconnect the glove box
lamp connector to remove the glove box inner cover.
(FIGURE E)
FIGURE D
ISSUE
PART NUMBER
H001SVC100/300
DATE
-
27 Aug 2021
FIGURE A
FIGURE B
FIGURE C
FIGURE E
SUBARU OF AMERICA
2 OF 10