Subaru H001SXC200 Manuel D'installation page 9

12
TRANSMITTER PROGRAMMING
1. Open the driver’s door and enter the vehicle. The driver’s door must remain open throughout the entire
programming process. Ensure all other vehicle doors, the engine hood and trunk are closed.
2. Verify that the transmission shifter is in the “park” position.
3. Turn the ignition “ON” then “OFF”, “ON” then “OFF”, “ON” then “OFF”, then back “ON” and leave on throughout
the entire programming process. (Turn ON the ignition by pressing the Engine Start/Stop button on the
dashboard two (2) times with an Access Key inside the vehicle. Do not press the brake pedal or the engine will
start.) (ON/OFF ignition cycles must be completed within twenty (20) seconds.)
4. The system will  ash the side marker lights, taillights and parking lights and honk the horn three (3) times
indicating that the system has entered transmitter learn mode.
5. Press and hold the
side marker lights, taillights and parking lights and honks the horn one (1) time, indicating that the system has
learned the transmitter. Release the
 ash/beep one (1) time.
6. Repeat step  ve (5) for additional transmitters. The system will accept up to eight (8) transmitters.
7. Turn the ignition OFF to exit transmitter learn mode.
8. Return to SECTION 11 to perform the POST INSTALLATION CHECKLIST.
NOTE: The system will exit the transmitter learn mode if the ignition is turned OFF, the driver’s door is closed
or thirty (30) seconds of inactivity.
PART NUMBER ISSUE
H001SXC200
button on the transmitter to be learned for three (3) seconds until the system  ashes the
button. Upon successful programming, the remote start transmitter may
DATE
- 24 May 2022
SUBARU OF AMERICA 9 OF 9
4281053 Rev - 5/24/22