Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
The ideal temperature range of the part and the vehicle when installing must be
1
SURFACE PREPARATION
2
REMOVE AND SAVE THE WHITE DOTS
Remove the white dots and stick them onto a smooth clean
non-porous surface for re-use later.
8
6
4
8
3
NUMBER THE WHITE DOTS
Use a soft tip marker to number each white dot as shown.
1
2
3
Part Number
E751SVC000
16ºC (60ºF) to 40ºC (104ºF), this guarantees a correct assembly.
2
1
4
2
5
3
6
Issue
Date
01
05/26/2021
INSTALLATION MANUAL
WRX/WRX STI - VORTEX GENERATOR
Make sure that all installation surfaces (shown left)
are clean, free of dirt, grease, and debris.
Use a clean, lint-free cloth and rubbing alcohol and
water solution (1:1 ratio).
Inspect vehicle for damage before installation of
Vortex Generator. The recommended adhesive surface
temperature range is 15°C - 43°C (60° - 110°F).
If the temperature is below 15°C (60°F), heat the
adhesive side of the Vortex Generator and roof surface
to a temperature of 27°C (80°F).
A one-hour cure time is recommended before exposing
the vehicle to extreme temperatures (hot or cold).
2
1
6
5
1
4
3
4
5
6
SUBARU OF AMERICA
White dots are there to protect
the part during shipment.
7
7
8
8
7
5
3
7
Page
2 / 7
Publicité
Table des Matières
