Subaru H001SXC200 Manuel D'installation page 5

7
PANEL RE-ASSEMBLY
1. Re-connect the glove box lamp connector to the lamp on the glove box inner cover. Re-install the glove box inner
cover by engaging the six (6) pressure clips and secure with six (6) Phillips screws.
2. Re-install the passenger’s side ornament panel by engaging the eight (8) pressure clips.
3. Re-install the right side dashboard panel by engaging the six (6) pressure clips.
4. Re-install the glove box and strut.
5. At the end of the installation, insert the Quick Reference Cards into the Owner’s Information Kit.
8
UNDER HOOD WARNING LABEL MOUNTING
1. Using alcohol, clean the top, right side of the radiator
core support.
2. Remove the release liner from the under hood
warning label and secure to the top of the radiator
core support, as shown. (FIGURE M)
9
SYSTEM POWER-UP
1. After all the connections are complete, re-connect the vehicle’s negative battery cable. Using a 10mm socket/
torque wrench, tighten the 10mm nut to 7.5 Nm +/- 2 Nm (0.76 Kgf-m +/- 0.2 Kgf-m, 5.5 ft-lbs +/- 1.5 ft-lbs).
2. Start the vehicle at least one (1) time using the Access key prior to activating the remote engine start system. This
is required to allow the vehicle’s electronic systems to re-synchronize.
3. With the vehicle running via the Access key, verify that the instrument cluster airbag light turns o . If the airbag light
remains on, refer to the vehicle service information for troubleshooting.
4. Refer to the vehicle Owner’s manual for the Power Window Reset Procedure to restore the power window functions.
PART NUMBER ISSUE
H001SXC200
DATE
- 24 May 2022
FIGURE M
SUBARU OF AMERICA 5 OF 9