Subaru H001SXC200 Manuel D'installation page 3

5
REMOTE ENGINE START ECU MOUNTING
1. Locate the glove box inner cover and carefully pull back
the insulation pad from the top area, as shown. Using
alcohol, clean the top and back side of the glove box
inner cover, as shown. (FIGURE F)
NOTE: Ensure the glove box inner cover is
completely dry.
2. Remove the release liner from the one (1) supplied wire
harness clip and attach it to the glove box inner cover,
as shown. Press  rmly in place for at least ten (10)
seconds. (FIGURE G)
NOTE: Ensure the opening of the wire harness clip
faces upward.
3. Remove the three (3) release liners from the remote
engine start ECU foam tape and attach it to the glove
box inner cover, as shown. Press  rmly in place for at
least thirty (30) seconds. (FIGURE H)
NOTE: Ensure the Remote Engine Start ECU
connectors will be facing forward, toward the
vehicle’s dashwall when reassembled.
PART NUMBER ISSUE
H001SXC200
DATE
- 24 May 2022
Insulation
Pad
Clean with
Alcohol
FIGURE F
FIGURE G
Wire Harness
Clip
FIGURE H
SUBARU OF AMERICA
Wire
Harness
Clip
Remote Engine Start
ECU
3 OF 9