Subaru H001SXC200 Manuel D'installation page 4

6
PRE-ARRANGED JUMPER HARNESS CONNECTIONS
1. Locate and release the vehicle’s 6-pin and 2-pin pre- t
connectors secured to the vehicle’s wire harness with
breakaway tape near the upper passenger’s side glove
box area. (FIGURE I)
2. When the vehicle’s 6-pin and 2-pin pre- t connectors
are free from the breakaway tape, unplug and discard
the 2-pin mating connector/wire jumper. (This is used
for the power window interrupt circuit).
3. Plug the remote engine start jumper harness 6-pin
and 2-pin connectors into the corresponding pre- t
connectors. (FIGURE J)
4. Secure the pre-arranged jumper harness connectors
and harness to the vehicle’s wire harness using two
(2) supplied 39cm tie wraps. Trim o the excess tie
wraps. (FIGURE K)
5. Plug the pre-arranged jumper harness 12-pin connector
into the 12-pin white port on the remote engine start
ECU, previously mounted to the top side of the glove
box inner cover (Step 5). (FIGURE L)
Route the pre-arranged jumper harness through the
wire harness clip. (FIGURE L)
FIGURE K
ISSUE
PART NUMBER
H001SXC200
DATE
-
24 May 2022
FIGURE I
FIGURE J
Wire Harness
Clip
FIGURE L
SUBARU OF AMERICA
4 OF 9