DeWalt DCE080RS Mode D'emploi page 23

First Time Pairing
®
1. On the DEWALT Tool
Connect™ application, click
2. In the list of DEWALT product
types, select Rotary Laser.
3. Enter a Name for the rotary
laser (e.g., DW080LRS/LGS).
4. On the laser keypad, press
and hold for 3-5 sec until the
Bluetooth ® connection turns on
(blue LED starts blinking).
5. When the application lists
the laser's model number as IN
RANGE, select it.
NOTE:
If the Bluetooth ® connection does not turn on, replace the D
18V battery.
5. On the laser keypad, press
connection to the detector.
® Tool Connect™ application, press Add a detector.
6. On the DEWALT
Enter a Name for the detector and press Connect.
7.
Turn on the detector and then press
8.
connection.
The DEWALT ® Tool Connect™ application will display information
9.
about the laser on the Diagnostics screen:
• If the current settings are one of the "favorite settings" you have
saved for the laser, it will display the name of that setting (e.g.,
Main St - Site 1).
• If the laser is dropped, disturbed, etc., it will send messages to
the Tool Connect™ application to inform you.
• If the Tracking feature is on, the application will know where the
laser is and will let you know if the laser has been taken and is
now out-of-range. (The Coin Cell battery enables the Tracking
feature.)
Paired Before
On the laser keypad,
. press
to turn on the
®
Bluetooth connection. The
blue LED will illuminate.
WALT
E
(Figure ) to turn on the
A 6
to turn on the Bluetooth
10. Select ACTIONS.
• If you are using more than one rotary laser and need to check
which laser is paired with the application, press the Identify
button at the bottom of the screen. On the paired laser, the
blue LED next to
• If you need to, you can enable, disable, or unpair the laser.
11. Select Rotary Control to change the setting for the rotary laser.
• When is selected, choose the rotation speed (150, 300,
600, or 1200).
15˚/45˚/90˚
• Select and choose the rotation angle (0, 15, 45, 90, or
360) and the rotation direction (
• Select and choose the Slope Setting, Axis Setting (X or Y),
Slope Configuration (% or degree), # degree or %.
12. Use your cell phone to control the laser.
When you are ready, turn the laser off from the Diagnostic screen.
13.
Unpairing the Detector from the Application
To unpair the Detector connection to the DEWALT
application and return to pairing the application with the laser unit, follow
these steps.
On the DEWALT ® Tool Connect™ application, unpair the detector
1.
connection on the Diagnostics screen.
®
2. Turn off the detector.
On the laser keypad, press
3.
connection with the detector. Once the detector is unpaired from the
laser, the laser will automatically switch back to being paired with the
®
DEWALT Tool Connect™ application.
You can then make sure that the laser unit is paired with the
4
application. On the ACTIONS screen, select the Identify button at
the bottom of the screen. The blue LED will flash on the paired laser
unit.
Then, if you want to unpair the laser unit from the DEWALT
5
Connect™ application, you can unpair it from the Actions screen.
will blink.
or ).
® Tool Connect™
(Figure ) to turn off the
A 6
GB
® Tool
23