DeWalt DCE080RS Mode D'emploi page 20

On the top of the display window, view the Accuracy Mode icon
4.
GB
(Figure ).
F 8
• indicates that the detector will give an "on grade" reading
only when the laser beam is on grade or no more than 1mm
(1/25") above or below it.
• To change the Accuracy Mode to
give an "on grade" reading when the laser beam is on grade
or approximately 3mm (1/8") above or below it, press the
Accuracy Mode button (Figure
) appears on the display window.
F 9
5. Position the detector so that the detector window (Figure
is facing the laser beam produced by the rotary laser (Figure
Move the detector up or down within the approximate area of the
beam, until you have centered the detector.
6. Use the marking notches (Figure
position of the laser beam.
7. To turn the detector off.
• On the detector, press
• If a rotary laser beam does not strike the detector's beam
detection window, or if no detector buttons are pressed, within
30 minutes, the detector will shut itself off.
Controlling the Laser Remotely
You can control the laser unit remotely in either of these 3 ways:
• From up to 15m away, you can use the remote to control the
laser unit (Figure
I 1
between the remote and the laser unit.
• From up to 30m away, you can use the D
Application on your Bluetooth ® device to connect to the laser unit
(Figure ).
I 2
• From up to 335m away, you can control the laser unit by using
Tool Connect™ Application on your Bluetooth ®
®
the D WALT
E
device to connect to the detector that is connected to the laser unit
(Figure ). You must press the Detector button
I 3
) on the laser in order to connect the detector to the laser unit.
6
20
to have the detector
) once. Then
F 3
) to accurately mark the
F 7
for 3 seconds.
). IR sensors will maintain communication
WALT ® Tool Connect™
E
Controlling the Laser from up to 15m Away
The DCE080RS/GS remote control allows you to operate and set
up the laser from up to 15m away. The LED light on the remote
control (Figure
B 1
DCE080RS/GS laser unit.
You can use all the buttons on the remote's keypad to control the
laser unit. To completely power OFF a DCE080RS/GS laser unit
using the Remote keypad, press the X-Y axis button
(Figure
) and the Slope Mode button
B 5
By default, the laser unit is not paired to a remote (the laser unit is
)
F 14
in Public mode). LEDs on the laser unit and the remote will indicate
).
G
that they are not paired.
Description A laser is in Public Mode
if it is not paired with a
remote.
A remote is in Public
Mode if it is not paired
with a laser.
Control A Public laser can be
controlled by more
than one Public remote
(Figure
A Public remote can
control more than one
Public laser (Figure
LEDs
The unlocked
will be lit on the laser
keypad (Figure
The locked LED on the
remote will NOT be lit
(Figure
(Figure
A
) indicates a signal is being transmitted from the
(Figure
B 2
UNLOCKED
in Public Mode
A laser is in Private
Mode if it is paired
with a remote.
A remote is in Private
Mode if it is paired
with a laser.
A Private laser can only
be controlled by the
remote to which it is
). paired (Figure
K 1
A Private remote can
only control the laser
to which it is paired
). (Figure
K 2
The locked
LED
on the laser will be lit
(Figure
and
K 1
).
K 2
The locked LED on
the remote WILL be lit
and ). (Figure
K 1 K 2
(Figure
) simultaneously.
LOCKED
in Private Mode
).
L
).
L
LED
).
L
).
L