Restoring The Original Configuration - SOMFY S&SO-RS100 Notice

2.4.5. Restoring the original configuration

Apply the double cutout only for the end-product to

be reset.
This reset deletes all programmed control points, all
sensors, all end limit settings and resets the favourite
(my) position for the drive.
Position the roller shutter at its half-way position.
1)
Cut the power supply for 2 seconds.
2)
Switch the power supply back on for 5 to 15 seconds.
3)
Cut the power supply for 2 seconds.
4)
Switch the power supply back on: the roller shutter
5)
moves for a few seconds.
Press the PROG button on the Somfy io-homecontrol
6)
control point for ≈ 7 s, until there are two back and
forth movements by the roller shutter:
The drive is now reset to its original configuration.
→
Resume the set-up operation (see Set-up section).
-
Copyright © 2014 - 2017 SOMFY ACTIVITES SA. All rights reserved.
1)
5 s
3)
ON
15 s
5)
ON
1 2
®
4 3
6)
PROG. 7 s
EN
2)
OFF
2 s
4)
OFF
2 s
my
x 2
45