Manufacturer's Warranty; Fcc Statement (Applicable In Us) / Ic Statement (Applicable In Canada); Notice D'utilisation Originale; Indications Relatives À La Documentation - Hilti BX 3-BT Notice D'utilisation Originale

Trouble or fault
Fastener driven at an angle.
10 Disposal
WARNING
Risk of injury due to incorrect disposal! Health hazards due to escaping gases or liquids.
▶ DO NOT send batteries through the mail!
▶ Cover the terminals with a non-conductive material (such as electrical tape) to prevent short circuiting.
▶ Dispose of your battery out of the reach of children.
▶ Dispose of the battery at your Hilti Store, or consult your local governmental garbage disposal or public
health and safety resources for disposal instructions.
Most of the materials from which Hilti products are manufactured can be recycled. The materials must be
correctly separated before they can be recycled. In many countries, your old tools, machines or appliances
can be returned to Hilti for recycling. Ask Hilti Service or your Hilti sales representative for further information.
▶ Do not dispose of power tools, electronic equipment or batteries as household waste!
11

Manufacturer's warranty

▶ Please contact your local Hilti representative if you have questions about the warranty conditions.
12

FCC statement (applicable in US) / IC statement (applicable in Canada)

The product complies with part 15 of the FCC Rules and RSS­210 of the IC.
Operation is subject to the following two conditions:
• This device shall cause no harmful interference.
• This device must accept any interference received, including interference that may cause undesired
operation.
Changes or modifications not expressly approved by Hilti can restrict the user's right to operate the
device.

Notice d'utilisation originale

1 Indications relatives à la documentation
1.1 À propos de cette documentation
• Lire intégralement la présente documentation avant la mise en service. C'est la condition préalablement
requise pour assurer la sécurité du travail et un maniement sans perturbations.
• Bien respecter les consignes de sécurité et les avertissements de la présente documentation ainsi que
celles figurant sur le produit.
• Toujours conserver le mode d'emploi à proximité du produit et uniquement le transmettre à des tiers
avec ce mode d'emploi.
1.2 Explication des symboles
1.2.1 Avertissements
Les avertissements attirent l'attention sur des dangers liés à l'utilisation du produit.
signalisation suivants sont utilisés :
12 Français
Possible cause
Fastening tool was angled off the
driving axis when pressed against
the surface.
Action to be taken
▶ Press the fastening tool at right
angles against the surface,
applying pressure to the grip
surface on the back of the
fastening tool.
2209577
*2209577*
Les termes de