Hilti BX 3-BT Notice D'utilisation Originale page 15

5. Release the fastener guide locking catch.
▶ The fastener guide locking catch jumps to the middle position.
6. Grip and pull the fastener guide to check that it is securely seated.
5.6 Setting fastener driving depth
1. Turn the fastener driving depth adjuster to the required driving depth.
2. Check the quality of the fastening in accordance with the instructions supplied with the fasteners. Every
time you make a change to the power level, you must use a new stud to do so.
Select the power level that suits the application.
If you do not yet have experience in working with the power tool, the recommended initial power
level is stage 3.
6 Operation
6.1 Switching on the fastening tool
WARNING
Risk of injury! Pressing the nosepiece of the fastening tool against a part of the body may lead to serious
injury due to inadvertent firing and release of a fastener.
▶ Never press the nosepiece of the fastening tool against your hand or any other part of the body.
WARNING
Risk of injury! Under certain circumstances, pulling the fastener guide back by hand could make the tool
ready to fire. When the tool is ready to fire, fasteners or the piston could be driven inadvertently into parts of
the body.
▶ Never attempt to pull the fastener guide back by hand.
▶ Press the on/off button.
▶ The spring mechanism audibly builds up tension and the status indicator shows green.
Battery performance drops at low temperatures.
When battery performance drops, tensioning of the spring mechanism takes longer than with a
fully charged battery.
If you continue to operate the fastening tool after battery performance drops, the fastening tool
will switch itself off automatically before damage to the battery cells occurs.
6.2 Switching off the fastening tool
▶ Press the on/off button.
▶ The spring mechanism audibly relieves its tension and the status indicator goes out.
6.3 Driving a fastener
WARNING
Risk of injury by incorrect handling and/or splintering material!
▶ Risk of driving a nail through your hand! Always use both hands to operate the product! Always hold
the product firmly with your second hand as illustrated.
▶ Never press the nosepiece of the fastening tool against your hand or any other part of the body!
By unintentionally triggering a driving operation, this can cause severe injury.
▶ Wear personal protective equipment and always wear protective glasses and protective gloves.
Other persons in the vicinity must also wear eye protection and a hard hat. When fasteners are being
driven, there is a risk of injury to the body and eyes caused by material splintering off the working surface
and also if there are foreign bodies in the area of the fastener guide.
▶ Never attempt to clear malfunctions of the tool by continuing to trigger the tool!
*2209577*
3
2
5
2209577 English 9