Barrette rdi FINYL LINE Mode D'emploi page 3

LEVEL RAIL INSTALLATION
1.
Closely follow Post Install Kit installation
instructions or use a Post Sleeve over an existing
wood 4x4.
2.
CUT RAILS TO LENGTH
a. Place bottom rail across post opening leaving
equivalent spacing from the last baluster and
post on each end (Fig. 1).
b. Mark
expansion (Fig. 2).
c. Align top rail with bottom rail and cut both
rails with miter box or hacksaw (see saw blade
manufacturer's specs for correct blade) (Fig. 3).
NOTE: You will have to cut through an aluminum
insert in each rail.
3.
SPACER BLOCKS
Cut two 2" temporary wood spacer blocks (not
included) to insert under ends of railing sections
to temporarily assist in aligning railing section
(Fig. 4).
⁄ " from end of post to allow room for
1
8
2" Spacer Blocks
Fig. 1
Fig. 2
Fig. 3
Fig. 4
3