Barrette rdi FINYL LINE Mode D'emploi page 11

I. USING PRE-MOLDED BRACKETS
1.
STABILIZE SECTION
a. Place assembled stair railing section
adjacent to mounted stair posts, leaving
equal distances from the ends of both
balusters and clamp your stair railing
section to the posts (Fig. 4).
b. Trace the post onto each rail (both ends of
top and bottom rails). Make four marks in
total being sure to mark
for expansion (Fig. 5).
2.
CUTTING RAILS
Remove clamped stair kit from posts. Cut
along all four angled marks on rails (Fig. 6).
3.
Slide the stair brackets onto the rails (Fig. 7) and
place rail section between your posts (Fig. 8).
⁄ " shorter to allow
1
8
Fig. 7
Fig. 4
Clamp
Fig. 5
⁄ "
1
8
Fig. 6
Fig. 8
11