Install Side Bracket Screws And Covers; Note: In Some Cases You Will Be Drilling Though; Aluminum As Well As The Vinyl Railing; Fig. 10 - Barrette rdi FINYL LINE Mode D'emploi

4.
a. Mark all bracket holes. Pre-drill all bracket
holes with
b. Drive screws through brackets into post using
#10 x
per bracket) (Fig. 9).
5.
INSTALL SIDE BRACKET SCREWS AND
COVERS
For each installed bracket, pre-drill in the center
of each elongated hole with a

NOTE: In some cases you will be drilling though

aluminum as well as the vinyl railing.

6.
Install #10 x 1" screws in all pre-drilled holes
(Fig. 11).
7.
Match letter on inside of bracket cover to the
letter on bracket, and snap cover in place
(Fig. 12). Repeat for all brackets.
12
⁄ " drill bit (Fig. 9).
1
8
" self-tapping square drive screws (4
11⁄
2
⁄ " drill bit (Fig. 10).
1
8
Fig. 9

Fig. 10

Fig. 11
Fig. 12