Explanation Of Buttons; Explanation Display Functions; Operation; Cleaning And Maintenance - Tunturi X100 Star Fit X-Bike Manuel De L'utilisateur

English

Explanation of buttons

Mode
Press mode button to select console functions.
-
Push and hold for 3 seconds to reset: TIME, SPEED,
-
DISTANCE, CALORIES & PULSE.
NOTE
Odometer can only be reset by a batteries
•
exchange.

Explanation Display functions

Scan
In SCAN mode, press MODE key to choose
-
functions.
Automatically scan through each mode in sequence
-
every 5 seconds.
The sequence of display when press MODE key
-
: TIME, SPEED, DISTANCE, CALORIES, ODO &
PULSE.
Time
Automatically accumulates workout time when
-
exercising.
It is not possible to set target , the computer will
-
start count up from.
Range 00:00 ~ 99:59
-
Speed
Displays current training speed.
-
Range 0.0 ~ 999.9
-
NOTE
Without any signal being transmitted into the
•
monitor for 4 seconds during workout, RPM will
display "0"
Distance
Automatically accumulates the distance from
-
exercise when exercising.
Range 0.0 ~ 999.9 KM
-
Odometer
Automatically accumulates the Total distance for all
-
exercise sessions.
Range 0.0 ~ 9999 KM
-
Calories
Automatically accumulates calories burnt when
-
exercising.
Range 0~999.9
-
NOTE
This data is a rough guide for comparison of
•
different exercise sessions which cannot be used
in medical treatment
Pulse
Current pulse will display after 6 seconds when
-
detected by the console.
Without any pulse signal for 6 seconds, console will
-
display "P".
Pulse alarm will sound when current pulse is over
-
the target pulse.
Range 0-40~240 BPM
-

Operation

Power on
Press any key to power on the console when being
-
in sleep mode..
Start pedalling to power on the console when being
-
in sleep mode.
Power off
Without any signal being transmitted into the monitor
for 4 minutes the monitor will enter SLEEP mode
automatically.

Cleaning and maintenance

The equipment does not require special maintenance.
The equipment does not require recalibration when
it is assembled, used and serviced according to the
instructions.
WARNING
Do not use solvents to clean the equipment.
•
Clean the equipment with a soft, absorbent cloth
•
after each use.
Regularly check that all screws and nuts
•
are tight.
If necessary, lubricate the joints.
•
Trouble shooting:
When the display of LCD is dim, it means the
-
batteries need to be changed.
If there is no signal when you pedal, please check if
-
the cable is well connected.
NOTE
When stop training for 4 minutes, the main
•
screen will be off.
If the computer displays abnormally, please re-
•
install the batteries and try again.
1 6