Subaru H001SVC000 Manuel D'installation page 7

10
SYSTEM POWER-UP
1. After all the connections are complete, re-connect the vehicle's negative battery cable. Using a 10mm socket/
torque wrench, tighten the 10mm nut to 7.5 Nm +/- 2 Nm (0.76 Kgf-m +/- 0.2 Kgf-m, 5.5 ft-lbs +/- 1.5 ft-lbs).
2. Start the vehicle at least one (1) time using the Access key prior to activating the remote engine start system. This
is required to allow the vehicle's electronic systems to re-synchronize.
3. With the vehicle running via the Access key, verify that the instrument cluster airbag light turns off . If the airbag light
remains on, refer to the vehicle service information for troubleshooting.
4. Refer to the vehicle Owner's manual for the Power Window Reset Procedure to restore the power window functions.
SYSTEM REGISTRATION
11
ENSURE THE SOFTWARE VERSION HAS BEEN UPDATED TO THE LATEST REVISION
BEFORE ATTEMPTING SYSTEM REGISTRATION.
DST-i SETUP
REGISTRATION
1. PRESS IMMOBILIZER ETC. REGISTRATION
AND PRESS SELECT
PRESS
3. PRESS H TYPE FOR PUSH START MODELS
PRESS CONFIRMED AND WAIT FOR LAPTOP
TO ESTABLISH CONNECTION
PART NUMBER ISSUE
H001SVC000/200
Plug the DST-i
diagnostic plug
into the vehicle's
diagnostic connector
PRESS
PRESS
PRESS
DATE
- 27 Aug 2021
Plug the DST-i
USB plug into a
Network-Enabled
laptop
2. PRESS WRX AND PRESS SELECT
With an Access key
inside the vehicle
turn ON the ignition
4. PRESS REMOTE ENGINE START CM
REGISTRATION AND PRESS CONFIRMED
SUBARU OF AMERICA
Select/Open the SSM4
software on the
Network-Enabled
laptop
PRESS
PRESS
PRESS
PRESS
PRESS
PRESS
7 OF 10