Subaru H001SVC000 Manuel D'installation page 6

7
PRE-ARRANGED JUMPER HARNESS CONNECTIONS, continued
4. Plug the pre-arranged jumper harness 12-pin connector
into the 12-pin white port on the remote engine start
ECU, previously mounted to the back side of the glove
box inner cover (Step 5). (FIGURE O)
8
PANEL RE-ASSEMBLY
1. Re-connect the glove box lamp connector to the lamp on the glove box inner cover. Re-install the glove box inner
cover by engaging the six (6) pressure clips and secure with seven (7) Phillips screws.
2. Re-install the passenger's side ornament panel by engaging the four (4) pressure clips and one (1) fi nger clip.
3. Re-install the right side dashboard panel by engaging the six (6) pressure clips.
4. Re-install the glove box and strut.
5. At the end of the installation, insert the Quick Reference Cards into the Owner's Information Kit.
9
UNDER HOOD WARNING LABEL MOUNTING
1. Using alcohol, clean the top of the air intake plenum,
near the radiator core support.
2. Remove the release liner from the under hood warning
label and secure to the top of the air intake plenum,
as shown. (FIGURE P)
ISSUE
PART NUMBER
H001SVC000/200
DATE
-
27 Aug 2021
FIGURE O
FIGURE P
SUBARU OF AMERICA
6 OF 10