Standard Equipment - Comet PTO RW 15/150 Manuel D'utilisation Et D'entretien

1 u
npackInG
fi«
warNING
• You must wear gloves and goggles when unpacking in order to prevent potential injury to your
hands and eyes.
• The pump unit is heavy therefore it must be unpacked by cutting the bottom of its cardboard
box.
• Do not leave packing materials (plastic bags, staples, etc) in the reach of children as they
could be dangerous.
• Dispose of packing materials according to local regulations in the country where the high
pressure cleaner is to be used.
Plastic bags and plastic packing materials, in particular, must not be discarded carelessly as
they are detrimental for the environment.
• After unpacking the high pressure cleaner, make sure it is intact and check that the identifica-
tion label and warning labels are intact and legible.
In case of doubt, do not use the high pressure cleaner and contact the Manufacturer or your
local dealer.
1.1 s e
tandard quIpment
Make sure the following parts are included in the two product boxes:
• pump (with or without step up gear unit, depending on the version chosen) complete with adjust-
ment valve, safety device and base;
• bag containing: the two oil caps with breather vent (32) and (33) (cap (33) is not provided with
the versions without step up gear unit), four screws (f) with relative washers, one-way washers
and nuts (for securing the pump);
• operating and maintenance instructions manual for the pump;
• guarantee certificate;
• chassis (23) in two separate parts;
• high-pressure hose (13);
• cleaner gun (14);
• lance hose (16) complete with nozzles;
• bag containing: the pin for the top tension rod on the tractor's three-point coupling (21) and
relative split pin (22), two plugs for the pins on the bottom tension rods on the tractor's three-
point coupling (20), spacer (30), three screws (a) with relative washers, one-way washers and
nuts (for assembly of the chassis).
In case of any problems, contact your dealer or the Manufacturer.
fi«
warNING
• This instructions manual, the instructions manual for the pump and the guarantee certificate
must always accompany the high pressure cleaner and be available for use by the end user.
2 a
ssembly of
fi«
warNING
• You must wear appropriate safety clothing (gloves, overalls, boots with steel toecap, goggles)
before starting to assemble the high pressure cleaner.
• The Specialised Technician must comply with the installation requisites provided in this
manual, especially as regards torque settings.
• Whenever necessary, only lift the high pressure cleaner using the appropriate harness/hook
at the point shown on the warning label with the black hook on a yellow background.
a) Place the base (d) of the semichassis (c) in a horizontal position. Operation E in fig. 6.
h p
the IGh ressure
c
leaner
EN - 35