Hamilton Beach 70550 Mode D'emploi page 9

Continuous Processing
Please see the Easy to Use
Assembly Guide on page 5.)
Continuous processing allows food to be pro-
cessed in a separate bowl when processing
large quantities.
IMPORTANT: For continuous processing,
insert food gate into slot of lid and make sure
the continuous feed disc is in place.
1. Make sure the Control Switch is turned to OFF
and the unit is unplugged.
2. Lock the bowl onto base. (See "How to Lock the
Bowl" on page 6.)
3. Put disc shaft onto motor shaft.
4. Place the continuous feed disc, ribbed side up,
onto the disc shaft. Turn the disc slowly until it
drops into position (level with top of bowl).
Continuous
Feed Disc
5. Select desired side of reversible
slicing/shredding disc and place that side up on
the disc shaft.
Slicer/Shredder
Disc
( available on selected models)
6. INSERT FOOD GATE WITH SHORT
SIDE DOWN INTO SLOT OF LID.
7. Lock on cover. (See "How to Lock the Cover" on
page 7.) Place bowl under feed chute.
8. Plug in unit and select speed. Process food. Check
the continuous feed chute frequently to make sure
the opening is not blocked. If blocked, turn unit off
and unplug. Clear blockage, then reassemble
and continue processing.
Motor
NOTE: When using the continuous feed chute,
Shaft
some food may fall into the food processor bowl.
Do not use the continuous feed chutefeature to
slice meats or cheeses or when shredding root
vegetables (carrots, potatoes, etc.). As with most
Motor
continuous feed processors, shredded moist
Shaft
vegetables may clog in the chute. It is best to
shred these vegetables into the food processor
bowl. Slicing these root vegetables while using
the continuous feed chute will not present a
problem.
Hint!
9