GYS START UP 80 Manuel D'utilisation page 11

Translation of the original instructions
• The terminal of the battery that is not connected
to the car frame must be connected first. The
other connection must be made on the car
frame, far from the battery and the fuel line.
The battery charger must be connected to
the power supply network.
• After the charging process, disconnect the
battery charger from the power supply
network and remove the connector from
the car frame and then the connector
from the battery, in this order.
Connection:
• Class II device.
• This machine is fuse-protected.
Maintenance:
• If the power supply cable is damaged, it
must only be replaced by a cable specified
or supplied by the manufacturer or its after-
sales service.
• Service should be performed by a qualified
person.
• If the internal fuse is blown, it must be
replaced by the manufacturer, its after-sales
service or an equally qualified person.
• Warning! Always remove the power plug
from the wall socket before carrying out
any work on the device.
• Regularly take off the cover and remove
dust with an air gun. Take the opportunity to
have a qualified person check the electrical
connections with an insulated tool.
• Under no circumstances should solvents or
other aggressive cleaning agents be used.
• Clean the device's surfaces with a soft, dry
cloth.
START UP 80
EN
11