R&G LP0197BK Instructions De Montage page 6

layer of wd40 or equivalent around the outer surface of the key lock and slide the rubber
grommet (item 7) in.

Mount the licence plate bracket (Item 4) using the four M6 x 16mm (Item 1) with M6
washers (Item 2) through the top four holes on the sub-frame. Secure the assembly with
M6 washer (Item 2) and M6 nyloc nut (Item 10) on each bolt as arrowed in picture 11.
Page | 6

Ensure that none of the wires are caught between the sub-frame and the licence plate
bracket (item 4). Tighten the four nyloc nuts (Item 10) using 10mm socket and a wrench
to 12 Nm.

Reconnect all the indicator wiring plug sockets and check operation (if illumination fails,
swap the bullet connections around).

From the kit, take the tail light resistor (Item 19) and fit the male connectors to the female
rear light connector in the main loom fitted earlier. Plug in this scheme:

Connect the tail light wires (Item 12) to the tail light resistor (Item 19). Plug in as
orientated below:

Route the wiring as original and tidy up using the cable ties provided from the kit.

OEM number plate light connector is no longer in use as the tail light unit (Item 12)
comes with built-in LED licence plate lights.

Fit licence plate to the new licence plate bracket (Item 4) (it may require re-drilling).

IMPORTANT: IF FITTING A FULL-SIZE LICENCE PLATE AND PLACING IT
FAR DOWN ON THE LICENCE PLATE HANGER, THERE IS A SMALL
CHANCE OF THE LICENCE PLATE HITTING THE BACK WHEEL UNDER
HEAVY LOAD AND OVER LARGE BUMPS IN THE ROAD. IT IS YOUR
RESPONSIBILITY TO CHECK FOR THIS POSSIBILITY AND TAKE
AVOIDING ACTION. FAILURE TO CHECK THIS COULD RESULT IN
SERIOUS INJURY.

Refit the Seat lock mechanism as original using its original bolts.

Refit seat.

Depending on local laws, attach enclosed red reflector (item 19) in an appropriate
location.

Please test the indicators, rear light, no. plate light and brake light before riding.
Digital copies of these instructions are available to download from
Unit 1, Shelley's Lane, East Worldham, Alton, Hampshire, GU34 3AQ
Tel: +44 (0)1420 89007 Fax: +44 (0)1420 87301
OEM YELLOW ---------- RESISTOR BLUE
OEM BLUE/ RED ------- RESISTOR YELLOW
OEM BLACK ------------ RESISTOR BLACK
TAIL LIGHT YELLOW ----------- RESISTOR YELLOW
TAIL LIGHT RED ------------------ RESISTOR RED
TAIL LIGHT BLACK-------------- RESISTOR BLACK
GENERAL TORQUE SETTINGS
M4 BOLT = 8Nm
M5 BOLT = 12Nm
M6 BOLT = 15Nm
M8 BOLT = 20Nm
M10 BOLT = 40Nm
ISSUE 4 04/11/2016 (HH)
R&G Racing
www.rg-racing.com
www.rg-racing.com Email:
6
LP0197
info@rg-racing.com