Prepare And Assemble Pet Feeder; Remove From Package; Clean Removable Parts - Petsafe PFD19-15521 Mode D'emploi

OPERATING GUIDE
STEP 1

Prepare and Assemble Pet Feeder

1A. Remove From Package
After removing pet feeder from box and
packaging, remove components located inside
hopper. Open lid by pulling back finger latch
then lifting lid up using finger grips. Remove all
components from packaging.
1B. Clean Removable Parts
All parts which contact food are made of BPA-free, food grade materials and should
be cleaned prior to initial use. These parts easily remove for cleaning. The washable
parts are: stainless steel bowl, bowl holder, hopper lid, hopper and conveyor. The
stainless steel bowl, bowl holder, hopper lid and hopper are dishwasher safe. Only
clean the conveyor by hand-washing using cool or warm soapy water. These
washable parts can be submerged in water. Rinse and let all parts air dry completely
before assembling pet feeder. Stand conveyor upright with front chute on flat surface
for best drying results. DO NOT use hot water, submerge the hopper base in water
or clean conveyor in an automatic dishwasher.
To Remove Hopper: Press hopper release
button on back of pet feeder then lift to remove.
Dispose of all packaging
materials properly. Some
items may be packed in
polybags; these bags
could cause suffocation;
keep away from children
and pets.
Do NOT immerse control panel in water. Base unit should
NOT be submerged in water at any time, as this may damage
electronic components.
www.petsafe.net 11