Petsafe PFD19-15521 Mode D'emploi page 24

Not dispensing meal sizes
programmed or no food at all.
Dispensing extra meals.
24
• Ensure hopper is filled with food.
• Check if pet feeder is in Pause Feed Mode.
Pet feeder will not dispense food until pause is
removed (see "Pause Feed Mode" section).
• Make sure pet feeder is not in Setup Mode. Pet
feeder must be in Operating Mode to dispense
food (see "Setup Mode" section)
• Ensure you are only using dry or
semi-moist food.
• Check if LCD screen is showing an error.
• Ensure conveyor agitator is positioned inside
back food chute on hopper with release
button locked in place (see "To Install
Hopper" section).
• Conveyor belt may not have been aligned
properly when installed, conveyor may be out
of sync with motor or the "prepare conveyor
with food" cycle may not have been run when
refilling hopper with food. Empty food, remove
hopper and conveyor. Reinstall conveyor (see
"To Install Conveyor" section). Press
ENTER and LEFT buttons AT SAME TIME to
cycle the conveyor. Remove conveyor again
and align lip on conveyor with arrows on
side of conveyor housing (see "To Install
Conveyor" section). Reinstall conveyor and
hopper. Refill with food. Press ENTER and LEFT
buttons AT SAME TIME until conveyor starts
moving and filling with food.
• Meal size/portion may be slightly off due to
type of dry or semi-moist food being used. Try
adjusting meal sizes accordingly (for example,
if pet feeder is dispensing 29 ml (1/8-cup) less
than programmed, increase meal sizes by 29 ml
(1/8-cup)).
• For any of the 12 meal options you do not want
to schedule, leave meal size field blank or set
to "--- cup" or "--- ml". Return to Setup Mode
by pressing and holding ENTER button for 5
seconds. Use buttons to check each of the 12
meals and ensure meal sizes are set to "---
cup" or "--- ml" for any meals you do not want
scheduled (see "To Set Custom Feeding
Schedule (User)" section).
www.petsafe.net