Compliance - Petsafe PFD19-15521 Mode D'emploi

Compliance

This equipment complies with the EMC and Low Voltage Directives. Unauthorised
changes or modifications to the product that are not approved by Radio Systems
Corporation may violate EU regulations, could void the user's authority to operate the
equipment, and will void the warranty.
The Declaration of Conformity can be found at:
http://www.petsafe.net/customercare/eu_docs.php.
IC
This Class B digital apparatus complies with Canadian ICES-003. This equipment has
been tested and found to comply with the limits for a Class B digital device, pursuant
to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference when the equipment is operated in a residential environment.
This equipment generates, uses, and can radiate radio frequency energy and, if
not installed and used in accordance with the instruction guide, may cause harmful
interference to radio communications. However, there is no guarantee that interference
will not occur in a practical installation. If this equipment causes harmful interference
to radio or television reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference by one or more of the
following measures:
• Relocate the interfered receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different to that to which the receiver
is connected.
• Contact the Customer Care Centre.
This device complies with Industry Canada Rules. This device complies with part 15 of the
FCC Rules. Operation is subject to the following two conditions: (1) This device may not
cause harmful interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
Unauthorised changes or modifications to the equipment, not approved by
Radio Systems Corporation, could result in not meeting compliance with FCC regulations
®
and could void the user's authority to operate the equipment.
ACMA
This device complies with the applicable EMC requirements specified by the ACMA
(Australian Communications and Media Authority).
www.petsafe.net 27