About This Sensor; Safety - ProMinent DULCOTEST CDE 2-mA-0,5 ppm Mode D'emploi

1
The CDE chlorine dioxide sensor is a diaphragm-covered amperometric dual
electrode measurement sensor. The chlorine dioxide sensor is used to
determine chlorine dioxide concentrations in surfactant-free water. Typical
applications for the type CDE 2 include the disinfection of drinking and
brewing water. The type CDE 3 is used in the chlorine dioxide treatment of
hot water of quality similar to drinking water up to 60 °C (e.g. combat against
legionellae). The sensor delivers a standard 4 - 20 mA signal via a two-wire
interface that is largely unaffected by water flow. Power is also supplied to
the sensor via the two-wire interface.
2
Correct use of equipment
The sensor may only be used to determine and regulate chlorine dioxide
concentrations (ClO
The sensor must not be used in water or solutions containing surfactants!
All other applications and modification of this equipment are prohibited!
The sensor is not electrically isolated!
CAUTION
• The sensor may only be used in ProMinent in-line housing types
• There must be free discharge from the in-line flow housing outlet.
• The supply voltage to the measuring device and the sensor must not
IMPORTANT
• The sensor may only be assembled, installed, serviced and operated
• Check the sensor regularly for dirt and deposits, check the
• Observe valid national directives for the maintenance, servicing and
®
ProMinent

About this Sensor

Safety

)!
2
DLG III or DGM. Otherwise flow parameters cannot be maintained!
(see section 15 "Technical Data")
be interrupted. After long intervals without power (more than 2 h) the
sensor should be given a further run-in period and recalibrated (see
section 7.1 "Run-in Period" and section 7.2 "Calibration").
by appropriately trained and authorised personnel!
diaphragm cap for air bubbles!
calibration intervals!
About this Sensor / Safety
19