Lifting Procedure; Risk Analysis; Maintenance, Transport And Storage - Mittelmann UniDrive Mode D'emploi D'origine

Original Operating Instructions UNIDRIVE
handwheel can be slowly relieved so that the load is taken over slowly by the manual force on the free
lifting gear end.
By slowly guiding the free lifting gear, the operator can now control the speed of the descent and stop
it at any time.
If the rope has not been guided over the eyebolt, the downward movement is stopped by the body of
the descender device being held with one hand and the other hand being pressed against the rotating
handwheel until the system comes to a standstill. Through the transmission ratio of the gearbox and
the design of the handwheel, the stopping is possible easily and free of risk of injury even from full
speed.

9.5 Lifting Procedure

The changing over of the direction of travel is done by moving the travel direction lever. If the lever is
pointing to the "yellow" position this indicates upwards travel, the "red" position indicates downwards
travel.
The changing over can only be done in the load-free condition of the release head, this means the
person must be held with the hand.
To change from downwards to upwards travel, the travel direction lever must be simply moved to "yel-
low". Upward travel begins immediately with the manual lift activation or with the activation of the cord-
less screwdriver.
For lifting motion, either the handwheel, the ratchet lever or a cordless screwdriver attachable to the
handwheel can be used. If a descent movement is to follow a lifting movement with the cordless
screwdriver, the screwdriver must be pulled out of the handwheel adapter beforehand.
Switching to downwards travel can, likewise, only be done in the load-free condition of the release
head, this means the descent load must be held with the handwheel.

10. Risk Analysis

In accordance with EN 12100. See Attachment:

11. Maintenance, Transport and Storage

Inspection and maintenance work on all parts of the UNIDRIVE must only be carried out by the
manufacturer's personnel or by persons authorized by him in writing.
Exclusively, only original Mittelmann spare parts must be used.
Page 23