Unpacking The Machine; Machine Components; Machine Setup; Installing / Replacing The Filter Bag - Tennant 3090 Opérateur Manuel Et Liste Des Piéces

UNPACKING THE MACHINE

1. Carefully check carton for signs of damage.
Report damages to carrier immediately.
2. Check carton contents for to ensure carton is
complete. Contact distributor for missing items.
1 -- Machine with Harness
1 -- 1.2M (4 ft.) Vacuum Hose
1 -- Accessory Kit, Includes: Upholstery Tool,
Crevice Tool, Dusting Brush, Floor Tool and
Telescopic Wand.
1 -- Paper Filter Bag (installed)
2 -- Exhaust Air Filter Cassette w/ Filter (installed)
1 -- HEPA Cartridge Filter (installed)
1 -- 15M (49 ft) Detachable Power Supply Cord

MACHINE COMPONENTS

12
11
5
2
1
6
7
13
1. Main Power ON/OFF Switch
2. High/Low Speed Selector Switch
3. Vacuum Hose Swivel Elbow Connector
4. Filter Bag Compartment Cover
5. Cover Latch
6. Dual Exhaust Air Filters
7. 1.2M (4 ft) Vacuum Hose
8. Vacuum Hose release Button
9. Vacuum Hose Nozzle
10. Accessory Tools
11. Adjustable Back Harness
12. Carrying handle
13. 15M (49 ft) Detachable Power Supply Cord
Tennant 3090 (05- -02)
Home Home
3
8
4
9
10
Find... Go To.. Find... Go To..

MACHINE SETUP

Prior to operating your machine, always check to
ensure that the Filter Bag, HEPA Filter and Exhaust
Air Filters are installed in the machine. Make sure all
filters are clean and that the vacuum hose, wand and
tool are not blocked with debris. Inspect power supply
cord for damage, replace if damaged.
For Replacement filters see the Parts List section of
this manual.
FOR SAFETY: When servicing machine, unplug
cord from wall outlet. Use manufacturer supplied
or approved replacement parts.

INSTALLING / REPLACING THE FILTER BAG

The machine is equipped with a factory installed paper
filter bag. The filter bag is designed with a self-closing
tab to promote hygienic, dust-free removal and
disposal of bag. To maintain optimum vacuum
performance, it is recommended that the filter bag be
replaced when it reaches two-thirds full.
1. To access the filter bag compartment, unlatch the
bag compartment cover and remove the cover
(Figure 1).
FIG. 1
2. To install a new filter bag, simply slide the bag's
cardboard plate into the bag support frame
(Figure 2).
FIG. 2
OPERATION
11