Moser 1591 Mode D'emploi page 10

ENGLISH
· Never insert or allow objects to fall into the openings of the appliance.
de
· Only use and store the appliance in dry rooms.
· Never use the appliance where aerosol (spray) products are being used or where oxygen is
en
released.
· To prevent injuries, never use the appliance if the blade set is damaged.
· Do not use disposable batteries. Rechargeable batteries should only be replaced at author-
fr
ized Service Centres.
· Before the appliance is used for the first time, it should be charged for approx.
it
16 hours.
· The appliance is safety insulated and radio screened. It meets the requirements of EU
es
Directive 2004/108/EC regarding electromagnetic compatibility and EC Low Voltage Directive
2006/95/EC.
pt
Exhausted batteries/rechargeable batteries should not be disposed of in household
waste. Dispose of them in completely discharged state in accordance with legal
nl
regulations.
sv
Charging the battery
· Connect the appliance plug on the plug-in transformer to the charging stand socket
ⓐ
no
(Fig. 1 ).
· Connect the plug-in transformer into the socket (Fig. 1
fi · Switch off the appliance using the on/off switch (Fig. 2
· During charging, the charging indicator (C) is illuminated.·
· Recommendation: the battery should only be recharged when the performance of the appli-
tr
ance has deteriorated considerably. However, charging the battery for longer than the speci-
fied length of time will not cause any damage.
pl
· It should take around 16 hours for the appliance to charge to full capacity.
cs
Battery operation
· Switch on the appliance using the on/off switch (Fig. 2
ⓑ
sk
(Fig. 2 ).
· With the battery fully charged, the appliance can be operated for up to 100 minutes, before
hu needing to be charged again. This capacity is attained after approx. 5 - 10 charging cycles.
· Note: In case of insufficient maintenance of the blade set, the operating time can be reduced
considerably.
sl
Attaching / removing the attachment comb
ro
· Slide the attachment comb on to the blade set in the direction of the arrow until it clicks into
position (Fig. 3
bg
· The attachment comb can be removed by pushing it in the direction of the arrow (Fig. 3
ru
Cutting with attachment comb
The appliance can also be operated with an attachment comb. The attachment comb has 5
uk
detent positions for adjusting the length of cut. The further the attachment comb is pushed in
(retracted), the shorter the length of cut. The length of cut can be adjusted from 3 mm
ⓐ
(Abb. 4 ) to 6 mm (Fig. 4
el
ar
10
ⓐ
).
ⓑ
).
ⓑ
).
ⓑ
).
ⓐ
) and, after use, switch it off again
ⓑ
).